the handle as to be put on, simple job, until I found that only 2 of the 3 pins were the right size, the third one was just a MM off and you could not put in the carder pin. so I hat to find something to use for the third pin . but once you get it put together . it dose work well . (note) it may say 1/2" working ports, and yes the two ports going the cylinder are 1/2" . it might have said in the there description . but I miss the part where it say the two ports coming from and back to the pump were 3/4" ports .
Upgrade Your Draft Beer Kegerator With The TerraBloom CO2 Keg Pressure Regulator - Dual Gauge Heavy Duty Unit With Safety Features
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review