Review on 🔥 Plasma Cutter Cutting Torch with SG-55 AG-60 Circinus Roller Guide Wheel Compass by Eric Broad

Well built but too big for the AG-60 torch. The inside diameter wasn't enough but there were only two set screws in the kit, I drilled and tapped two additional holes, now I have three screws 120 degrees apart and I added slightly longer screws to center them. Haven't used it yet, but it's stable and doesn't wobble like two screws. Smaller shims were also replaced to place the tip 1/8" off the work surface. Tried it on a 1/4" slab and works like a charm.