Fast! Simple common sense to use and install. (NOTE: The upward orientation is marked on the grommet. You simply feed the wires through the designated wire hole on the grommet, then insert the grommet into the bumper. Connect the wires to the light, then slide the light all the way back the grommet as far as it will go. Pull the grommet forward and lift its edge up as far around the hole as you can. Then use a screwdriver or fine-nose pliers to grasp the outside edge of the bushing and work around the metal hole edges, until fully snaps in. Works great with 4" Maxxima MWL-12 Round Flood Beam LED work lights which I bought to hook and unhook a work trailer. Also for hunting and other outdoor lighting needs a large head screwdriver to turn the Pry up the edge of the rubber edging and squeeze out the sealant around it.
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
25Pcs Fender Liner Screws For Toyota Avalon Camry Corolla Scion Lexus - OEM #90159-60498
35 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review