Review on Fluorescent PLA plastic Bestfilament 1.75 mm for 3D printers, 1 kg, yellow by Micha Spodymek ᠌

Really nice print, straightforward settings. My print speed is 210 and my table speed is 60. The figure is nothing more than a bomb. In addition, I purchased several different types of plastic because I was looking for one that was particularly deserving; however, the end result is that they all get stuck, then they don't like something about the temperature (despite the fact that everything is done in accordance with the recommendations), then it sticks off, then it is smeared; this model has none of these issues, but there is one that is particularly annoying. The second time I tried to print the figure, I had to spend a lot of time and rework it because the plastic would become knotted in the middle and would not feed into the printer. The third time I tried to print it, I had to unwind everything and figure out where the knots were.