Header banner
Revain logoHome Page
Loren Schmidt photo
1 Level
1315 Review
47 Karma

Review on πŸ”© Left Hand Metric M14 Thread by Loren Schmidt

Revainrating 4 out of 5

A very good death. in dies for round threads

I have been a machinist for over 25 years. This stamp is as good as most regular stamps I've used. I would recommend removing the detent and spring from the front sight. Since this die is used for threading gun barrels I would like to see only one side of the starter and the other side with a small starter could be used for threading closer to the front sight. But a crush washer helps fill in a small gap if it bothers you. Also, drilling the clam's beak a few thousand deeper will bring it closer to the scope and latch. The Matrix seemed a little tight, or my shaft was a little bigger than most. An adjustable matrix would be ideal. I had to remove quite a bit of metal from the barrel to thread it. I used a thin file and sandpaper and used a caliper to make sure it stayed round. I highly recommend using the die hole guide available from Brownells.

Pros
  • dies for round threads
Cons
  • Dear