Review on 🎨 Gizmo Dorks Opaque Filament Printers: Unleash Your Creativity with High-Quality Prints by Matt Conner

I used the same thread as part of a multipack and it was a 200g spool. Worked great and I have pretty good mini prints with it. I bought a full 1kg roll and can't get decent print quality. Constantly under-extruded surfaces, even when I get too much squeezing on the first layer because my nozzle is too close to my layer it seems to have trouble sticking to itself. I get a lot of pimples and bumps on the sides of my casts. Prints often warp off the bed if borders are not used. I've played around with table temp, nozzle temp, flow rate, print speed, retract speed, and distance to name a few that helped a bit. However, nothing compares qualitatively to the first 200g green bun I had before. Edit: The manufacturer sent me a replacement roll and it prints great. I must have a bad role