Review on 🔧 Dowel Jig with Offset Scriber Line System: Perfect Woodworking Tool for Accurate Straight Hole Locating, Drill, and Marking with Self-Centering Scriber Line & Wood Dowels Pins by Jacob Leon

Three sizes of dowel sets (10mm, 8mm and 6mm) are used with this tool. a few scraps of wood and made a small cube to try it out. (see photo of the process). A 10mm screw in the center of the dowel jig, then a drill of the same size. Now attach the drill collar of the same size. It may take some time to set the correct depth, then use an Allen key to secure. Tip: If the wood is thin, you can always shorten the wooden pencil. and center the dowel tool. Hold the dowel jig in place or it will move towards you, also rotate it and the bottom pins will not allow movement. The bottom pins can be easily moved to different positions. Twist them between two fingers. Drill a hole and insert a thimble into the hole. At this point you can press the tip against the other piece of wood you want to join. Attach the jig to this point and drill. Now you can insert the dowel and tighten dry. Glue when done. marker element. Work with the 8mm screw as it will fit best. 10 is too big and 6 is too small. Plus, the notches on each side are great for adding lines to your project. 1/16 3/16 5/16 7/16 and 1/8 1/4 3/8 1/2 Press firmly against the edge of the tree. The quality is very good. I prepared three small pouches for three sizes. You get 20 dowels of each size, enough to get started and get used to using the tool. A great gift for anyone who enjoys working with wood. I hope that was helpful.