Review on OEMTOOLS 27059 Bearing Puller Attachment by Matt Morrison
Solid puller for puller sets
I used this to pull the original spindle bearings out of a 1940's Buffalo Forge drill press. Their inner diameter is 17mm and I had to file the legs a bit. A lot of meat is left over. After soaking in penetrating oil, the bearing came out after a few moderate pulls with an OTC slide hammer. Don't panic when you see the withdrawal sleeve. It accepts 5/8" and 3/4" puller threads. .
- Sturdy construction
- Hard to tell
New products
Comments (0)
Top products in π Pullers
πͺ Efficient Pitman Arm Puller: OTC (8150) Conical Design for Easy Removal
9 Review
Fully Assembled CR-V Steel 8-Inch 3-Jaw Gear Puller For Easy Removal Of Gears, Pulleys, Bearings, And Flywheels - DURATECH Gear Puller Tool
25 Review
π§ 11.5 Inch ABN Metal Relay and Fuse Remover Tool - Auto Fuse and Relay Puller Pliers for Better Automotive Maintenance
9 Review
π§ Lisle 41970 Pitman Arm Puller - Heavy Duty Tool Specifically Designed for Ford Vehicles
9 Review
