Review on 🚗 Efficient Cleaning with AmazonCommercial Flow-Through Car Wash Microfiber Mop - 1-pack by Cameron Head

I needed a better way to wash my RV. I used a sponge floor mop and a hose, which is a difficult and tedious way to clean when you're trying to hold both at the same time. I have decided to order two RevainCommercial products - the RevainCommercial Flow-Through Car Wash Microfiber Mop and the RevainCommercial Flow-Through Car Wash Brush. This review covers both products as I feel others may be just as interested in ordering both products as I am. I really like both products, but there are improvements that could be made. None of these upgrades require a downgrade. Connected to a garden hose, both devices deliver water through the handle directly onto the washable surface. This simple design eliminates the need to constantly spray water on surfaces to wash away dirt and debris. Of course, regular rinsing of the mop head and brush head is required to ensure dirt is not rubbed into the surfaces. The microfiber mop head can be removed for washing and there seem to be regular replacement mop heads that fit. One improvement I'd like to see in both products is a water distribution channel built into the head instead of the current design where water only flows out from one point in the center of the brush head and two points near the center. Mop. This change allows the water to flow more evenly over the surface being cleaned. Of course, such a system is slightly more expensive to manufacture. Although the functionality of the pens is similar, the design of each stylus is slightly different, but not enough to justify the comments. Both handles are aluminum, have detachable heads, a water shut-off valve at the base of the handle, and are lengthened by loosening a sleeve and adjusting the length, then tightening the sleeve. A standard garden hose can be easily connected to the devices. Each includes a quick coupler that can be used on hoses with this type of attachment. The devices form a watertight seal and not a drop drips from any joint. The amount of water flowing out of the nozzles can be controlled either by hose pressure or, in the case of a mop, by a non-return valve. The brush shut-off valve is not adjustable; it is either fully on or fully off. An improvement would be to have an adjustable mop-type shut-off valve mounted on the brush. The mop head is made of soft, scratch-resistant microfiber material. The brush head has soft bristles, which I don't think scratch, but you should still be careful. One thing to be aware of is that the mop gets quite heavy when wet. I believe that if the bar is subjected to too much stress in the horizontal position, it can bend when fully extended. So don't shake it horizontally. This is another improvement, a larger tube for the mop handle. The handle on the brush is quite large.