Review on 🎵 ARCHEER 2 x 45W Mini Hi-Fi Amplifier: Bluetooth Stereo Receiver with Bass and Treble Control for Home Theater PA Car Tablet PC, Studio Use by Chris Hossain

For reference I refer to the Boomerang Lizard test from 12/20/2020. Everything Lizard wrote is true. My remote control was delivered without a battery. Photos posted by Lizard show the CR2025. I installed one and the remote works. The lizard replaced the power cord because the pins on the plug are flat and the plug is not firmly attached to the outlet. I took a different approach. With the help of pliers, I slightly bent and twisted the pins. The connector is reliable. I looked at the EQ settings from EQ 0 to EQ 5. My system sounds best with EQ 1, but the amp defaults to EQ 0 when turned on. Below the display are the buttons VOL-, SCAN and VOL+. Set the amplifier to radio mode and press SCAN. The amplifier works with the FM disc and assigns the stations that it can recognize to channels P0, P1, P2 - Pn. The VOL+ and VOL- buttons do not adjust the volume. Use VOL- and VOL+ to switch between channels P0 to Pn. Alternatively, you can access the station directly using the remote control. For example, to set 91.5, enter "915". FM reception is poor. The VHF antenna is a 13 inch insulated wire that comes out of a hole in the amplifier's case. Within the amplifier, a single cable occupies one port of a dual port jack that plugs into two pins on the amplifier board. Obviously one of the pins is not getting a signal. I clumsily attached a two-wire VHF-T antenna cable to the board, but didn't notice any better reception. My antenna knowledge is still in its infancy. If the reader has any ideas, please let me know.