Review on Prusament 1.75mm Filament: Optimized Diameter Tolerance for Additive Manufacturing Products by Michael Wehrman

later so Prusa filament. Everyone talks about it as well. As far as I know it is considered a thread high. So I pulled the trigger. 50+ costs paid. I have to say this is by far one of the worst threads I've ever used. I have several filament printers and on none of them have I been able to get it to stick to the build plate. All my cars have heated glass panels. I tried everything I could think of to make it stick. It was ensured that the plates were very clean. Increase the pace. Decreased in tempo and everything in between. I made spaghetti monsters. Thought it might be the printers. Moved to other threads. All are printed and glued to the mounting plate. I'm not sure what exactly is going on, other than maybe I'm having a bad throw. All I know is that I will never buy a Prusa again. I've used Tecbears, esun, hatchbox and a few other brands. Never had as many problems as with the Prusa. I'm by no means an expert but I know if it's hard to use why spend twice as much when you can use another brand and it works.