Review on 🗄️ Innovative Liberty D80622C 22 Inch Bearing Drawer for Organized Storage by Robert Espinoza

As long as you follow the instructions (I didn't do the first half of the install oh!) the drawer slides slide in very easily. They are also very strong. I actually only installed the front and middle screws (the back ones are very difficult to get to) and the drawer doesn't flex at all when fully extended unless I lean in. I would say the drawer can easily hold 10 pounds or more. Some suggestions/recommendations: 1. Get a tool to hold your slides; They are difficult to hold with one hand and try to negotiate with the other with a screwdriver. I used masking tape which was effective but had to be reapplied a couple of times. Pre-drill holes for the screws! This simplifies the installation of the screw by about 100 times.3. You should also invest in either a very strong magnetic screwdriver bit or one of those socket bits to hold the screw in place while you try to get it in the hole. I spent about 10 minutes tightening these stupid screws. I finally gave up and drilled a much larger pilot hole than I wanted. All of these things turned a 5 minute installation into a 30 minute desperation exercise. But let me be VERY clear here. These defects were MY fault, not the product. I installed a custom drawer in the 11 inch opening of a 15 year old desk. Not the easiest project, but it works. Now you have to attach a writing tray to the other side (!).