Review on Rear Axle Bearing Puller Set for HFS by David Robinson
Do not buy puller sets
Package arrived I was damaged and well packaged but that's where the good reviews end. A 1"-1 7/8" puller was used on a 2000 Jeep Wrangler rear axle bearing. I removed the seal with a seal remover, put the tool on my slide hammer and then after three hits on the slide hammer the tool failed. Then I had to figure out how to unlock the tool and get it out of the axle tube. This product is not built to last and most likely will not last the entire job.
- Some small things
New products
Comments (0)
Top products in 👊 Pullers
ABN 6in 2-Jaw Gear Puller: Essential Tool for Efficiently Removing Gears, Pulleys, and Flywheels
9 Review
🔧 Astro Pneumatic Tool 78825 25-Piece Master Front Wheel Drive Bearing Puller Set with Grade 8 Drive Bolt
9 Review
🔧 11.5 Inch ABN Metal Relay and Fuse Remover Tool - Auto Fuse and Relay Puller Pliers for Better Automotive Maintenance
9 Review
🔧 Pro-Grade 18212 4" ADJUSTABLE 2 OR 3 JAW GEAR PULLER: Ultimate Versatility for Efficient Gear Removal
9 Review
