Review on 🧩 Dexter K7138400 Conversion Set by Jay Kenville

Overall my camper is about 7 inches taller which makes it work MUCH better with my f350. Before that, almost all of the weight was on the rear pair of tires. Doesn't go nearly straight. You may need an extra step when you're done. It took a few hours to get dressed (unfortunately it was about 112 hours that day). Expect to need a flashlight to remove old hardware and BEWARE OF THE BRAKE CABLES! Also pay attention to the position of the axes. They should return to the exact same position they were taken off (you basically lower the spring mounts, allow the axle to go down, then put the springs back on top and secure). It had everything I needed except for a few small pieces of wire to extend the brake cables on one side. Took a camper from Michigan to South Carolina over the mountains the following weekend and it worked out great! Just take the time and watch the video online if you have any questions! The axes will bend in the middle and when you're done you'll want to make sure they're still bent!