Review on 🔑 High-Quality Car Key Fob Keyless Entry Remote for Mitsubishi Outlander, Endeavor, Eclipse (OUCG8D-525M-A, G8D-525M-A) - Set of 2 by Philip Lindsey

It took me a while to figure out how to program the remote control for my car because I really don't know anything. But I did it! If you have trouble, do the following: 1. Put the keys in the ignition to the OFF position. 2. Lay on the floor on the driver's side and using a small paper clip, insert each end into port 1 and the other end into port 4 of the data link connector. These are little holes you put the ends in and I was wrong about that. And yes, my back hurt because there wasn't much room to lie down. 2. Within 10 seconds of this connection, jump into the car, close the door and turn the alarm on and off 6 times. signal lights? I asked if I knew what you meant by emergency lights, but yes, your emergency lights. (Do this while holding your lucky bunny's paw 😁) The door locks will work once, indicating successful entry into programming mode. PRESS the LOCK button on the first programmable remote three (3) times within ten (10) seconds. The door locks will work once, indicating successful programming. REMOVE the jumper connected to the data link port.