🔑 High-Quality Car Key Fob Keyless Entry Remote for Mitsubishi Outlander, Endeavor, Eclipse (OUCG8D-525M-A, G8D-525M-A) - Set of 2 Review

I got this key fob for my 2004 Mitsubishi Endeavor after many years without the original. The programming sequence of using a paper clip and activating the alarm 6 times within 10 seconds is complicated but worth it in the end. I know I would spend a lot of money having a new remote programmed at the dealer. Especially considering how old my Mitsubishi Endeavor is. And unlike the original remote control; Good thing there is no panic button. Those who have had them know what I'm talking about.

So I couldn't get mine to work on a 2006 Mitsubishi Outlander Sport. I followed the instructions and the car responded as it should, but didn't sync to the fob. I stuck a paper clip into ports 1 and 4 of the DLC connector and pressed the alarm 6 times. The locks worked which is a good sign. Then I pressed the lock button on the key fob 3 times and the locks worked again. I removed the paper click but the car didn't respond to the key fob. I'm not sure if I'm missing something or if it just…

It took me a while to figure out how to program the remote control for my car because I really don't know anything. But I did it! If you have trouble, do the following: 1. Put the keys in the ignition to the OFF position. 2. Lay on the floor on the driver's side and using a small paper clip, insert each end into port 1 and the other end into port 4 of the data link connector. These are little holes you put the ends in and I was wrong about that. And yes, my back hurt because there wasn't much…

Worked great on my 2004 Mitsubishi Outlander. Very easy to program:1. LOCATE the Data Link Connector (DLC) pictured above. It is located under the dashboard/steering column on the driver's side.2. IDENTIFY DLC ports 1 and 4 in the diagram above. Note the metal contacts in connectors 1 and 4.3. INSERT the key into the ignition switch and leave it in the OFF position.4. JUMP ports 1 and 4 with an appropriate jumper. Any metal wire (paper clip) will do. Ensure constant contact between the metal…