Review on ⚙️ CMT 299.112.00 10-inch Table Saw Blade and Sanding Disc Set with 5/8-inch Bore by Stanley Molden

Some say using it on a table saw burns wooden objects. I haven't encountered this problem, but when I use it I want to quickly remove a ton of stuff and have confidence that it gets done! For fine sandpaper, use a hand sander or a low power sander, it is designed for sanding large amounts of material in a hurry. If I turn it over and use it to set up a table saw blade, it works very well. Runout 0.002 front to back, pretty even. I wish it was a little better as my typical runout tolerance on this saw is 0.002 so I don't have a lot of wiggle room. The disc itself is 1/8" thick and 10" full diameter, lots of bulk and fits perfectly on my 5/8" mandrel (I have a JTAS-10XL) so it's a keeper.