Switched to this cooler from Enermax Liqmax II. I was planning on keeping this cooler on my new build, but unfortunately I lost the backplate adapter. I didn't need the 2011 chipset from my previous build. I chose enermax again because it worked great for many years. The worst thing that happened is that the LED on the pump went out after 3 or 4 years. I don't usually care much for RGB stuff, I bought Aquafusion because of the price. Unfortunately, my motherboard doesn't support addressable RGB lighting, so I had to use the controller that came with it. Having to press the backplate against the board when aligning the pump block and then trying to install the spring screws is just agony. The pump has been detached from the processor multiple times. I just hope the paste is still evenly distributed. Temperatures seem ok but a little higher than my last build. It could just be a difference in the processors.
300Pcs Black Replacement Screws Kit for Lenovo Toshiba Gateway Samsung HP IBM Dell Sony Acer Asus Laptop Notebook Computer SSD Hard Disk SATA
5 Review
🔩 Enhance Repairs and Upgrades with 400pcs Laptop Screws w/Blue Nylok – Premium Titanium Nitride Screwdriver & Notebook Computer Screw Kit Set
3 Review
🔧 TWYZONE Set: 10pcs Repair Replacement Screws + 1pcs Philips Head Screwdriver for Unibody MacBook Pro - A1278 A1286 A1297 - Bottom Case Compatibility (Not for Retina Display)
6 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review