Review on Joy Sunday Cross Stitch Kits: Classical Scenery Style Cross-Stitch 🧵 Embroidery Sets (14CT Stamped Kit, The Girl Sitting on The Dragon) by Jessica Lewis

ok i really like this galaxy print it will be beautiful what can i say here are my questions .1. 100% NOT ENOUGH CUT! I love the very thick cross stitch. I think it just looks better when it's finished, ie. H. I use the whole thread without dividing it, so I knew I would have to get additional threads. I actually only ordered 2 of the same product because it ended up being a lot cheaper than buying threads separately. This thread should have sufficed, before it was always enough, but as you can see in the picture I ran out of both dark blue colors (yellow and pink squares). And I haven't even finished the project yet. I have to buy it for the third time. Not cool. However, it's still cheaper than buying a crappy ton of yarn separately. The positive side of this is that I can cross stitch the same image three times but change the colors! I will have the original, maybe purple and. I don't know green? 2. This material is very strong, very thick and frustrating to work with at times, I've broken 4 needles so far and again haven't even finished. However, this is the first time I've had a material that has been stitched around the edges to keep it from fraying, which is lovely. instructions, what the hell? It took me a few online articles and hours of thought to figure it out, but once I figure it out it's pretty simple, the fact that there are symbols on the fabric with no other explanation as to what thread color it goes to fits (fits on paper) If you order this don't lose the instructions as you will never understand what these symbols mean. Why couldn't they have symbols and their meanings on fabrics? Why put symbols on fabric at all? No, you get symbols on fabric and explanations on paper. Very strange.4. Seal. I'm a little concerned that when I'm done and I have to put the piece in water to dissolve the printed color that it could seep into the filaments and potentially change the color of the filaments to a lighter color. I haven't seen a review or question about this yet. All of this and I still love this project. At the very least, they should be adding LOTS more threads to the stack. I'm sure if I split the thread as instructed I'd still run out.