Review on 🔮 1" Gray PETG Filament - Enhanced with Improved SEO by Cameron Reed

I was looking for cheap PETG filament and ordered this one. It was well vacuum packed and looked very good. However, initially the prints were full of cracks, threads, and the thread sometimes got stuck in the titanium thermal break. I wanted to write a negative review. However, the operating temperature turned out to be a problem. I installed a PT100 sensor and calibrated the printer nozzle to an accuracy of +/-0.5°C as the original Ender3 readings were 10-15°C (lower) based on the thermistor. The recommended printing temperature on the spool was given as 230.26 °C. In fact, at these temperatures, the material flows out of the nozzle and softens in the throat. I tried typing at 210C and a speed of 30-35mm/s, a pullback of 3.5mm and a bed of 75C and that fixed the problem. There were still some (very small) strings left when I tried to print the bridges, so I'm giving it 4 stars. But it's no worse than PETG+, which I tried from another manufacturer. PETG is still a bit more difficult to process than PLA, but the hardness and accuracy are better.