Review on Cable Pass Through Wall Port by Tom Goodlow

I bought 3 5/8" - 5 1/4" to run HDMI and USB cables in my recording studio. Not in the cabin itself, but in the room where the cabin is placed. There was an old "wire under the door carpet" until I replaced the carpet. I couldn't bring myself to put on a new carpet and I didn't want the cables to get pinched by the door when it was closed, so I got one of those instead. Installation was pretty easy. I used a long router with an extension for the pilot holes so the center router had room to pass through and fit together on either side. It is recommended that a second person hold a page and I did, and it worked like a charm. Be careful not to overtighten Since it's plastic and can break, just have the other person hold the end while you get the job done. One person could install on their own if they use tape to hold the other end. It looks like a 3D printer was used but the one I got seemed really sturdy and the ends were smooth and nice. Nice solid pieces and installed in about 10 minutes and took longer to set up and clean than installation. Overall I'm very happy with it and will definitely be buying more. and installed them in about 10 minutes, and the preparation and cleaning took longer than the installation. Overall I'm very happy with it and will definitely be buying more. and installed them in about 10 minutes, and the preparation and cleaning took longer than the installation. In general,