Review on Partsam Submersible Trailers Snowmobile Compliant by Kantrel Tunstill
The studs should be about half an inch longer to make it easier to attach the light to the license plate bracket.
They seem well made although I haven't tested them on the road yet. The design made it difficult for me to attach them to my trailer. The studs should be about half an inch longer to make it easier to attach the light to the license plate bracket and attach the washers and nuts. Since the wires come out directly from the back and not the side, I had to drill holes in the trailer to pull the wires through so they don't get pinched. Much more work than necessary. And of course the ground wire must be attached to a stud, ideally with a ring terminal.
- Pleasant to use
- Good but not great
New products
Comments (0)
Top products in 🔧 Trailer Accessories
🚗 LIMICAR Trailer Lights: Upgraded IP68 Halo Glow Kit for Trucks, Marine RVs, Boats, and Campers - Brake, Stop, Turn, and Tail Lights with License Plate LED - Includes 25ft Wiring Harness
16 Review
🧲 MUTUACTOR 2Pack 100lb Anti-Scratch Neodymium Rubber Coated Magnet: Versatile Magnetic Base for Off-Road Vehicle Lighting, LED Working/Signal Lights, Antenna, and More!
17 Review
Nissan Brake Control Wiring Adapter: Tekonsha 3050-P - Enhanced for Seamless Integration
10 Review
Upgrade Your RV Connection With LATCH.IT RV 7 To 6 Trailer Wire Kit V2.0 – Weatherproof, Flexible And Easy To Install!
19 Review
