Review on 🚲 Efficient Linear-Pull Brake Compatible SONGMICS Bike Cargo Rack, Rear Carrier (USBC01B) by Bobby Diaz

Nut on 10mm seatpost adjusters. If you have a 10mm socket and an extension this will be your friend. Do not place extension poles in the rack or your tire will likely not clear. You have to have them on the outside (sliding parts. I would also recommend flipping the bolt over so the nut is on the outside as well. Otherwise try to tighten the nut from the back and the little wrench they give you will do the trick Doesn't have much leverage Overall the build is pretty tricky as most bike racks are welded all over the place but the contact points on the frame side for example I don't know why they went that way and didn't just weld them on because there's no adjustment to the Sides of the rack at the top contact points, just down where it connects to your rear triangle Juggle the half-assembled loosely bolted parts until you finally set it up, then tightening the whole thing up tight makes everything else in the rack a lot smaller than floppy drives, and you need less tightening when you're done.