Review on 💡 Mictuning HD 14AWG 300W LED Light Bar Wiring Harness with 40 Amp Fuse, Relay, ON-OFF Rocker Switch - Blue (2Lead) by Anil Campbell

Overall, I've managed to get this suspension to work for my needs, but I definitely lack foresight as to the overall proportions of this suspension. Pros: - Wire gauge is pretty good at 1416 AWG and there are more than enough wires to fit most of the kit without modification. - Correct shrinkage throughout, including connection to the relay. - Saved me a lot of time assembling a complete wiring harness. and wiring for relays, switches, etc. Cons: - Wiring to the actual headlights was grossly disproportionate and too short to reach the passenger side ditch light for a mile. I had to make my own extra "pigtails" to connect the wiring harness to the headlights and get this kit to work. It took about 2 feet of wire, a few extra connectors, and a solder joint. Fortunately, I already had the necessary materials on hand. However, the wire length from the relay circuit to the driver's side lamp connector is too long. So, without adding anything, if the manufacturer adjusted the splice to that length, then the kit would be perfect. I didn't follow the instructions at all when plugging in the switch as it would result in the switch light being on all the time as others have pointed out. I actually used another switch that matches mine perfectly and wired it up to work with the internal noon circuit as it should. The wiring instructions are very generic and appear to have been written for several different iterations of the harness. Not very helpful and luckily there is a lot of data on the internet about it. Happy wiring!