Review on URO Parts 32 094 306 by Faten Teller

The power steering hose fitted well but beware: the metal hose at the end had a lot of burrs around the brass tube where it was cut and shaped. I had to use a screwdriver to deburr the edges and then use an air hose to blow any metal shavings out of the tube to keep them off my power steering pump. They can be hard to see in photos, but this flare went all the way around the pipe and amounted to 5 or 6 large flakes by the time I finished deburring. Remember you will also need a Viton O-ring for sealing. to the end of the cooler. If these hose manufacturers would start including quality new o-rings in their parts, they would likely receive fewer leaking fitting complaints.