The adjustment of both the blade and throat are by the "loosen and tap” method. The two sets of screws -one set knurled, the other slotted- are clamps, not adjusters.The machining was decent quality, except the foot and the flat of the blade appeared to have been hand-dressed together, to make them look shiny and sharp (both showed grain running across the tool, not in line, as a proper pre-sharpening should appear). Both were slightly un-flat. Flattening the small blade was a chore.After correcting the problems, and slowly adjusting the blade, the tool works for the gentle seat back curves I wanted to create. But I know it will take much of the same effort again to handle the next shape I want to cut.I guess I felt mislead by the prominent brass adjuster screws- this isn’t like other spokeshaves that are adjusted that way.
Tubing Cutter 1/8 To 1-3/8 Inch For Pipe Copper PVC Thin Stainless Steel Tube With Extra Blade And Reamer
30 Review
3-Pack FOSHIO Utility Knife Retractable With 30 Degree Snap Off Blade For Vinyl, Paper & Craft Cutting
39 Review
DEKO 196-Piece General Household Hand Tool Kit - Includes Rip Claw Hammer, Lineman'S Pliers, Measuring Tape, And Plastic Toolbox Storage Case
32 Review
Make Clean And Precise Holes With Adorox Heavy Duty Leather Belt Puncher - Includes Ruler And Deburring File
34 Review
Wireless Electronic Ballast Interface Certified
8 Review
💡 Electronic FL Ballast ICN-4P32-N (Formerly ICN-4P32-SC) for 3-4 F32T8 F40T8 F17T8 Lamps, 120V/277V Compatibility
5 Review
💡 Hydrofarm Quantum QT400 Dimmable Ballast for 400W Grow Lights
5 Review
🔌 Robertson 2P20132 Quik-Pak: 10 Fluorescent eBallasts for 2 F40T12 Linear Lamps, Preheat Rapid Start, 120Vac, 50-60Hz, Normal Ballast Factor, NPF, Model RSW234T12120 /A (Crosses to RSW240T12120 /B)
4 Review