Review on Amooca Mud Flaps Mud Guards for Chevy Silverado 1500 (2014-2018) and 2500 3500 (2015-2018) - Custom Fit, No Drill, Flare Splash Guards Kits - Molded 4 Piece Set (NOT compatible with GMC Sierra) by Ahmed Rowe

Just installed them on my 2014 Silverado. Here are a few things that might help if you decide to buy them: Start on the driver's side, the front ones are very easy to fit, just loosen the four screws, slide the plastic back into place and screw tighten it again. the back with one is a bit difficult. The rear small piece of metal on the driver's side that goes up was the one for me, at first I thought its center side piece would squeeze the fender between the fender and medal clip, but it's actually the smaller end (see pic)...the Drawings are for the locked and unlocked position, my instructions only showed the other side so I didn't understand them) On the passenger side it got confusing for me. But it turns out both metal clips I got were for the driver's side and I didn't get any for the passenger's side. To fix this and get the driver's side working I just use pliers and bend the small part of the medal that is sticking out so you can see when it's locked and unlocked. Spread them out and compare, making sure the smaller side is pressing against your wing. I cut some fabric and taped it to the part of the medal where it would put pressure on my wing just because I'm weird and worried. about how he scratches the medal even when it's inside. I'm happy with that. Much luck!