Review on 🚀 Labwork Diesel Turbo Vane Position Sensor - Compatible with 2004.5-2015 Duramax LLY LBZ LMM LML 6.6L Engines by Yousef Abood

Got codes P003A and occasionally codes P2563 on my 2011 LML Duramax with 60,500 miles on the odometer. After doing a lot of research, I was pretty sure the codes were related to the bucket position sensor, but didn't want to spend more than $400 on a Delco AC factory replacement part. Decided to try this cheaper part. The part appeared to be well made and looked just like the old factory part. Fitted a new part and have not received any new codes after driving over 250 miles. I can say that the truck has more power at lower revs. A few things to note: 1) You will need a 1" sensor socket to remove/replace the sensor. 2) Disconnect both negative battery cables before replacing the sensor. 3) After replacing the sensor, turn on the ignition until the CEL lamp goes out, and then start the truck. Some say you have to take the truck to the dealer to have the new sensor programmed, but I followed the procedures above and had no problems. The ECM actually relearns the new sensor while the vehicle is being driven. Happy with this new sensor and happy with the money saved too!