Review on Nickson Industries 17705 Exhaust Elbow by Vladimir Castillo

I used this manifold to blow out the exhaust ahead of the rear axle after removing the factory muffler. The first photo shows the original Nickson elbow in situ. In the second picture you should see that I cut some parts at an angle and painted them black. I did this to point the exhaust port backwards a bit and painted it because it was slightly visible through the wheel. This elbow is a much cheaper alternative to a real branch pipe. Very happy with the purchase and the Nixon overall. (I used a 45 degree Nickson elbow on a 2004 F150. I went with a 90 degree angle here because I'm closer to the rear axle with this setup.)