Review on [initeq] 6-32 Threaded Heat Set Inserts for 3D Printing (Pack of 100, Short Length) by Doug Darling
Are they marked with M4 x 0.7 inserts?
Thread #6-32 is screwed in about 5 turns and then screwed in. Screw #6-32 also wobbles a bit when screwed in. Also, only 51 out of 100 received claims. Interestingly, if you look at it in the light, it shows QTY 50 M4 x 0.7. It would be interesting to try the M4 screw with it. Edit 12/07/2021. I tried an M4 bolt with these bits marked #6-32 and yes they fit perfectly.
- Easy to use
- Accessible when replacing
New products
Comments (0)
Top products in 🔩 Nails, Screws & Fasteners
Computer chair Zombie 10 gaming, upholstery: imitation leather/textile, color: black
56 Review
Wall-ceiling lamp Estares Saturn 60W R-470-SHINY/WHITE-220-IP44, 60 W, 47 x 47 cm, armature color: white, shade color: white
13 Review
Amino acid Prime Kraft 2:1:1, green apple, 150 gr.
27 Review
🔩 Eowpower 50 Pieces of 1/4"-20 x 7/16" Zinc Plated Tee T-Nuts with 4 Prongs
10 Review
Another interesting products
🌳 Efficient Drip-less Wood Glue Dispenser, 16 Oz Bottle
8 Review
Silver Holographic Stars Glitter Grout Tile Additive 100G - Easy To Use For Tiles, Bathroom, Wet Room & Kitchen
14 Review
Hemway Glitter Grout Tile Additive: Sand Gold Sparkle For Your Bathroom, Kitchen And Wet Room Tiles - Easy To Use And Temperature Resistant!
10 Review
Eco-Friendly Solarez UV Cure Grain Filler & Sealer - Perfect For Fine Furniture, Guitars, Pool Cues And DIY Woodworking!
10 Review