Review on Case Thermaltake Core V21 (CA-1D5-00S-1WN) by Wiktor Sakowski ᠌

A cool cube, for small systems or systems on the whole circuit its the very thing. In terms of size, it is, of course, decently larger than v1, but hence there are more opportunities. A 330mm long card easily climbed in, until the whole system was in the air, there was a CM Hyper T4 tower on the CPU, it also got up without any problems, but I had to remove the top covers a la "radiators" on the operative, there were no problems with temperatures, that's all within the normal range. On the blower on the lid there is a foam rubber duster or something, in short, it collected dust well, as well as a 200mm fan, there are no complaints about it either, it doesn’t fart, it doesn’t crack, you can only hear a little bit of air. It can be replaced with the same 200mm, 2x140 or 2x120, but if you are not a fan, then just hammer it, it does its job perfectly. I now have a p14 pack from the Arctic, two for blowing in instead of 200mm and three for blowing out plus on the Noktua redux p12 radiator, there are no problems with airflow from the word at all because, again, of the holey body, even despite the fact that arctic - it's about static, you can put a couple of airflow on blowing and forget. There may be some problems with cables, because. there is no management cable as such, so it’s better to immediately get a modular power supply unit, some of the problems will disappear immediately. I laid most of the cables under the board. In short, you can do it beautifully, but you have to get confused, I just scored) The only thing is that I had to drill the bottom cover for installing the pump, because. the video card covered part of this lowest cover. In the rest, an excellent compact beautiful and, most importantly, a well-ventilated case for such a size, without any problems in assembly. If you need a case for a super-small assembly, then it’s better to look at analogues from silverstone, fractals or the same tts, since there is now a considerable choice. If you need something bigger and more powerful, then this is one of the best options in terms of assembly and cooling problems.