Review on Ultimate Industrial Upgraded Heat Press 12X15: 8 in 1 Swing Away Shirt Printing Machine for T-Shirt, Hat, Cap, Mug & Plate - Digital Sublimation Press Combo by Sasha Hsiao

Let's start with the most unpleasant thing - the lid press. The instructions say the tray slides out easily. No no. Everything is screwed. The video shows how the bottom of the lid is threaded between the tray and the frame. But the video also shows a thread sticking out of the base. There aren't any. You will receive a cover base and two pan head screws. It is literally impossible to insert any of the screws without removing the stop or guides. And this requires the dismantling of a part of the machine. Either take a screwdriver and remove the stops that prevent the tray from sliding off, or remove the guides. The lid system is almost impossible to use once the tray is in place. Extremely bad design. I removed the stops and moved them to the back of the rails so they prevent the tray from moving too far. Now the tray pops out, but I have to be careful not to pull too far. At the same time, another problem was revealed - the rails for the tray are made of only two aluminum slats. There are no bearings and they can bind. They should be stored like drawer slides. The rest of the car is just fantastic. The controls are convenient, the temperature is accurate, the timer is accurate. The cup tool is completely separate from the main machine - it only uses the control box. The top of the machine gets hot, but not hot enough to burn you. Below is only one table and does not heat up.