Review on A-Team Performance - Enhanced 102mm Throttle Body Sheet Metal Intake Manifold with EFI - Perfect Fit for Chevy, GMC, Pontiac LS LS1 LS2 LS6 (Black) by Dan Tsourvakas

I ordered this for my 2002 transmission, I was hoping it would be an exact match without many modifications, the first MAP sensor hole was too big (modification was necessary. As next the PCV connector is NOT THEM (need to make a connector, the evaporator connector is not theirs, had to make a connector again if you have this car, they are right behind the throttle body. The next fuel line is a quick connector that snaps into place on the original ones Fuel rail More a mod I spent days and hours on these mods to get it working And 238.89 for parts bought to run oh don't forget to tune the power to calibrate the ECM so that it will work in harmony with your new 102 Intake Manifold/Throttle Body 575.00 in total for this upgrade of my car 1 400.00 not counting my time then when i finally got a chance it started it reached 5200rpm and there is nothing i can do to lower it except engine turn off, I restart and turn off again 5200 rpm / min I was very nervous about the possible explosion of this engine, and then about it, and then after half it will go down to 1000 rpm, I will know if there is gas there, the body squeaks like a belt, after researching I found that the port drilled into the tile body is wrong hence the iRock motor not seating properly causing excessive suction into the air intake. I was told that you actually need to increase the port a little more and get the IAC seats of another modification right, while driving the car on a weak engine, it jerks, it starts to accelerate, it starts, from 1000 to 1500 revs / min to accelerate then to 2000 and when you drive up to the traffic light you can feel how the car tries to jerk and drive. So be careful I did more research this way and they say the actual throttle position sensor is not in the correct orientation of the voltage gauge so now you have to go to both screw holes and make them elongated and move them back and forth, to get the correct readings. and correct tension is another modification again. This whole project took me a total of seven days to get the parts and work on it so it should take less than 24 hours. Wouldn't recommend this to anyone, it looks good, it looks very nice, but no one took a Kia to make sure the parts fit properly and conform to your car. So be careful with other reviews and you will make the right decision. Well-known manufacturers Holly, Bank, FAST, you pay a little more but you will not have these problems and you will get a customer service team to help you overcome any obstacle you encounter because I was left alone without help. nothing but heartbreak and heartbreak from the seller and recommendations and when you're done with all that extra money on how you spend it makes it cheaper to buy one of the other manufacturers. c And wait and wait another day goes by and you get 0 help at work we need someone need technical help you there product they sell 600.00 and you are alone I would not recommend this item see attached video