Review on Boao Adjustable Stainless Steel Clamps by Sam Lund
Lots of threads suitable for hydraulics, pneumatics and plumbing
I bought this clamp to fix a rattling catalytic converter heat shield. I was hoping the thread would be long enough to reach deep enough. I didn't measure my transducer at first, but I thought it was 6" to 8" in diameter. If this clip is 24 inches long, I'll cut off about 6 inches when I'm done. There were many more threads that could be used if I needed them. A quick estimate will be 50% thread. In theory, you can easily clamp between 4 and 8 inches.
- Pretty impressive
- Drill kit
New products
Comments (0)
Top products in 🔧 Fittings
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
Joywayus 5/8" ID Hose Barb Hex Union Brass Fitting Water/Fuel/Air With 10 Stainless Steel Clamps (Pack Of 5)
13 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
