Review on Comidox 2Sets DHT11 Digital Temperature Humidity Sensor Module 3.3V-5V for Arduino Raspberry Pi (Including Dupont Connector Cable) by Chad Mills
Inaccurate temperature detection - 1 degree Celsius resolution
This module appears to work directly with the standard dht.h and dht.cpp code libraries. I use it with Arduino Mega. But that's not very accurate. The temperature appears to be about 2 degrees above normal. I don't think it was very well calibrated. 1 degree Celsius equals 2 degrees Fahrenheit.
- Can detect ambient humidity and temperature
- Crumpled
New products
Comments (0)
Top products in ๐ฅ๏ธ. Single Board Computers
๐ MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
Another interesting products
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
MacBook Retina 13-inch (A1425, A1502) and ๐ฉ 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review
๐ฅ๏ธ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review