Review on 🪚 Enhance Your Woodworking Finishes with the Roundover Edging Router 4 Inch Cutter by Scott Ramu

Update. The nozzle manufacturer contacted me and asked me to take a photo of the problem. After reviewing the photo I sent them saw They saw the problem and wanted to take it to the engineers to fix it. They offered to send more or refund the money. It was good customer service. That's why I've upgraded my rating to four stars. I've given it a try Only given four stars because I haven't had a chance to try other beats to see if they might have problems, but I don't think they will.I put the router on the table and removed the bearing to to see how it cuts. I cut well. I still couldn't use a bit because I was routing an edge on a round project. I bought the set primarily to use the 1/8" bit for the Artike l which I'm doing right now. I installed it in my router and pressed the router against a piece of wood to make sure the router was configured properly. I noticed that the bit didn't cut the wood. Then I examined the bat. The bearing of the 1/8" bit extends well beyond the inner cutting edge so it will not round off the edge. The bearings on all 4 bits are the same size. I have contacted the supplier about the issue. Will update when the Supplier replies I ordered another bit from another manufacturer.