Review on π§ Enhance Your Brewing Setup with CellarBrew Splicer Stainless Reducing Fitting by Aaron Franklin
Low Tolerance Connector
This is a poor quality, tight tolerance fitting and will not fit high tolerance lines such as nylon or rubber fuel lines (see photos). the inside of the line and cause a restriction or flow problem. I needed this for a nylon fuel injector line and the tolerance is so far out that the 5/16 side of the gear fits the 3/8 nylon line - the 5/16 side doesn't even try to fit. When I used the heat gun to put it on, it ripped the 5/16 line to apply pressure.
- Barbed hose adapter for connecting to both ends for two different inner diameter hoses.
- Slightly torn
New products
Comments (0)
Top products in π§ Fittings
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
DIGITEN DC 12V 1/4" Inlet Feed Water Solenoid Valve Quick Connect N/C Normally Closed No Water Pressure
14 Review
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
1 Inch Beduan Brass Electric Solenoid Valve, 12V Normally Closed Air Valve For Water, Gas, Fuel, And Oil
10 Review
Another interesting products
π§ Thermoplastic Aluminum Fitting Equipment by SAFBY
3 Review
Ultimate Performance: SpringSpray Aluminum Equipment Heavy Duty Industrial for Optimum Productivity
3 Review
Fill Rite 5200F1790 Nozzle Spout Threads
3 Review
Flexaust 611S Polystyrene Cleaning Crevice: Versatile and Efficient Solution for Deep Cleaning
4 Review