Review on 🔧 DURATECH 3-Inch 3-Jaw Gear Puller, Gear Removal Tool for Pulleys, Gears, Bearings, and Flywheels, Pre-Assembled, Made of CRV by Brian Cruz

Name: 🔧 DURATECH 3-Inch 3-Jaw Gear Puller, Gear Removal Tool for Pulleys, Gears, Bearings, and Flywheels, Pre-Assembled, Made of CRV
Item: 🔧 DURATECH 3-Inch 3-Jaw Gear Puller, Gear Removal Tool for Pulleys, Gears, Bearings, and Flywheels, Pre-Assembled, Made of CRV
Rating: 2

September 06, 2022

The 3-inch model's range is shorter than advertised.

This would be an OK product if it worked as advertised but it doesn't. The range of the 3 inch model is advertised as 3 9/16 inches but as you can see in the photo it is closer to 2 9/16 inches. I needed about 3 inches of reach to grab the bearing and it wasn't enough for my application. As mentioned by others, bent jaws can damage seals. If you are replacing a worn or dead bearing, this is not the case. makes a difference if you damage the old one, but if you need to remove and reinstall the bearing then this isn't the right tool for the job.

Pros