Review on 🔧 Enhance Suspension Performance with APDTY 035181 Rear Leaf Spring Insert 20870046 by Adam Mazie

They are made of hard plastic and can tear. One cracked when I pushed it in while pressing the round disk. To avoid tearing, place the pin in the hole and then have the top spring push it inward by jacking up the bottom spring or allowing the weight of the truck to compress the leaf springs. I used a jack because I have air springs so there is a gap between the overload spring and the rest of the stack, like an unloaded truck. I had to replace them because they were completely worn out from the always fully loaded truck. and riding on the overload plate. Now that I have air springs it's not a problem but it was obvious that new pads were needed and they were making noise. I would just like to know that they are easy to hack.