Review on Computer case AeroCool Cylon black by Adam Wawrzyski ᠌

Very badly blown. There is only one fan in the kit and in the closed state, even in idle time, the temperature inside rises. Bought 2 more 120mm. I put it on the front panel, but it's useless because there are no holes in it. They are circling the air inside. I added another 100mm to the top side for blowing (120mm rests on the VRM heatsink). It got a little better, but under load the temperature still rises. The upper type "filter" had to be removed as it strongly slows down the air flow. In general, it is still open because the gtx1060 in conjunction with the xeon 2689 is not cooled normally. I'll find a drill and drill holes in the front panel. I hope it helps ated. I made an additional hole in the front wall. It got better, but since there are only two fans on the front wall, I had to seal the remaining hole with a film so that the fans would not drive air in a circle. At work, I tried two other cases when building a PC. Zalman i3 and Deepcoll Matrex 55. Zalman is about the same, but Matrex 55 is much better. It’s better to pay a little extra, but take it and not sweat it later.