Review on 🔌 Efficient Cooling Control with BN-LINK Digital Thermostat for Fans 40-108F 8.3A 1000W by Steven Loy

the thing works great. Just plug it in, press and hold the "up" button for 3 seconds to display the Fahrenheit scale. Press and hold the "Down" button for 3 seconds. If you want a Celsius scale, press and hold the yellow button for 3 seconds to adjust the time up or down. Press the yellow button again and the sensor will be placed where you want to set the temperature. I drilled a hole in the side of my solar panel. This device is not waterproof. So if you use it outdoors like I did, make sure it's protected as well as the sensor. I use it as a thermal switch for my solar pool water heater. I made a solar panel with 50ft of copper tubing inside encased in glass [2 of them]. I wanted this switch to be on the swamp. a pump located in a basin 18 inches below the surface. I wanted this to happen when the solar panel hits 100f. not on the timer because some days it rains. I connected it to this drain pump. which directs water to solar panels located 6 feet below the pool's surface. At a distance of 0.15 feet from the pool. = OH_AUI_I_D_OLD_O6? 5 foot glass solar panels. Each 50-foot copper pipe inside can raise the pool temperature by about 10 degrees. I'm on 60 gallons per hour. hours it raises the entire pool anywhere from 1 to 3 degrees more than the sun itself in a day. The pool is 8600 gallons so in 14 days the entire pool got 10F warmer than the sun itself. Works especially well at the beginning and end of the season to extend your pool usage