1 Level
1282 Review
53 Karma
Review on π§ͺ MG Chemicals Structural Milliliter Pneumatic Solution by Rodney Gonzalez
Great gap filler for multi part 3D prints
MG 9200 is a great gap filler I have used in some of my multi part 3D prints by sanding the surfaces and then applying some excess then gluing them together. The parts are fitted together and then the gaps are cleaned up with a piece of foam or spare cardboard leaving a quality finish and creating an extremely strong bond. will buy again!
Pros
- Epoxy Adhesives
Cons
- Not as thick as other materials
New products
Comments (0)
Top products in π§ Epoxy Adhesives
Extra Deep Pour Epoxy Resin Kit - Teexpert 2-4 Inch Crystal Clear Casting Resin For Jewelry Making, Wood Filler, Resin Molds, And Coasters (24Oz, 2:1 Mix Ratio)
4.47
4 Review
Clear Gorilla 2 Part Epoxy Syringe, 5 Minute Set, .85 Ounce (Pack Of 6)
4.51
32 Review
Creative set for painting with epoxy resin in Resin Art technique "Sea"
5
5 Review
π¨ Crystal Tumbler Painting Project with Accurate Measurements
3.97
7 Review
