The glass of the side wall is tempered, showing the assembly at its best. Taking it off is easy. you can install 5-6 fans, 2 on top, one on the rear panel for blowing, and two or three on the CBO radiator on the front panel. But the solid front panel is not designed for strong airflow. Has pros: It looks solid and beautiful, the quality of workmanship and materials, steel, glass, I like it. There is an RGB fusion application where you can set the colors of the backlight, and its pulsation. Some cons: CBO can only be installed on the side of the front panel, either 240 or possibly 360. If you install the CBO 240 radiator on the front panel, then there will not be enough space on it for another cooler. I had to remove the cooler that was there, native from aorus.
CZH-LABS Electronics-Salon Prototype Shield Kit for 🛠️ Raspberry Pi - Ideal for Breadboard DIY Projects
13 Review
🔌 UCTRONICS GPIO Breakout Kit for Raspberry Pi Pico - Assembled Pi T-Type Breakout + 830 Tie Points Solderless Breadboard + 40 Pin Male-Female-Male Rainbow Ribbon Cable + 65pcs Premium Jump Wires
10 Review
DSD TECH 2 PCS IIC OLED Display 0.91 Inch: Perfect Arduino ARM Accessory
9 Review
Complete Kuman Raspberry Pi 4B 3B+ Kit: Breadboard, Expansion Board, Jumper Cables, Ribbon Cable, Resistance Pack
9 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
11 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
🖥️ Helifouner 450-Piece Computer Standoffs Spacer Screws Kit: Ideal for Hard Drive, Motherboard, Fan, Power Graphics & Computer Cases
10 Review
🔧 Premium Repair Replacement Screws & Tools for MacBook Pro Retina 15"/13" - Complete Bottom Case Set
10 Review