Review on WEN DPA2412T Drill Press Adjustable by Jesse Runninger

This table is perfect for the woodworking workshop. This is the perfect size for my Ryobii DP102L. Installation on a standard metal table took about 2 minutes. The clamps that come with it seem to hold it very securely. It arrived with a few nicks on the edge of the laminate, but I'll make more of this as I work. The edges are nicely rounded. The edging material is applied well; there are no places where the workpiece can get caught. The edge stitching is on the back of the table, so the manufacturer appears to have noted a previous complaint that this is visible from the front. The T-rails in the table appear solid, but they're only held in place by three screws set into the MDF material, so I'll probably have to replace them with a more secure solution later. The railing T-track is not metal, it is simply cut into the MDF board and left unfinished. Functional but ugly. I can raise and lower the table with the drill press handle without interference. The fence doesn't interfere with the ABS handles, so I don't use it for most of my work. If necessary, I can easily attach it without moving or removing the table - a pleasant surprise. I have ordered 4 Rockler T-track work clamps direct from Rockler and expect them to work well with this WEN table. I took off a star because the fence got in the way, the shavings it came with, the fence's T-slot was cut into the MDF board rather than the metal track, and standard screws instead of real T-screws for fastening were used. pictorial guide. But I would buy it again. For me, the price was right, the size was right, installation was easy, and the protector is easy to remove and replace. I would have spent more making a copy of this spreadsheet than it would have cost to buy it ready to use.