Review on 🔧 ProSwitch™ - Advanced Interchangeable Nozzle System by Johnny Bloomer

I wasn't sure if I should glue everything together or "stubble". It's quite big, I like the stand at the bottom. Only recently have I discovered the use of hot glue. I re-upholstered a guitar case a while back and it was essential. I made this project with a regular craft glue gun and wanted to upgrade it for future use. The bottom was 1/8" hardboard, the sides were OLD 1/2" chipboard. I glued the bottoms with wood glue and narrow staples. I was about to bring them inside when I noticed that the staples pierced the fiberboard in several places and the glue wouldn't stick. Perfect time to try out your new hot glue gun! Worked well and glued well. There won't be any noticeable pressure pulling this connection apart, so I'm sure the connection will do. I like the big sticks in this big glue gun, but I wasn't sure about the yellow glue; it seemed quite hard but seemed to come out with blisters. It did a great job but I'm curious to try other glue sticks. I like the detachable power cord and power button - a bit redundant, but nonetheless. You can keep it on your desktop without disconnecting it, so that's a plus. I didn't have the usual problem of glue dripping out of the nozzle, I'm not sure if it was the thicker glue or the gun not really getting warm enough. The glue seems to have spread enough. As far as I could tell, it held my two inferior "wood" products together pretty well. great, it might fit the description of "pro" a little bit, but to be honest I haven't had any issues with the temperature, nor have I felt the need to change it. Jet. At least with the latch on the stand, this is not an important detail. If I find need for it later, I can probably bend something that works.