Review on Motion 100KHz Controller Breakout Engraving by Tim Hull

I've tried other cards like the red as well as more expensive NV cards and this was the easiest to set up and install and I didn't have it. Problem setting two motors on one axis. It immediately recognized the slave axis. I can't speak to its ability to drive a spindle or VFD, I use a USB to RS232 adapter from a PC for that. As far as traffic control goes, it's a great map. Hint about the map, steppers are driven negatively. So don't connect the negative wires in series. Daisy instead performs positive roles. Thanks very much!