Review on Enhanced Dimensional Accuracy with 📏 Filament FOXINK Consumables: A Comprehensive Review by Dan Barrett

This review is for FOXINK 3D printer filament. Its size is 1.75mm and I checked it with calipers in several places on the reel. This is a 1kg spool which is medium weight. Roll color and quality. I received this in blue, which I really liked. It's lighter and lighter blue than the other coils I have. The reel itself is of good quality. It lines up nicely on the reel, they wrapped it up really well so I doubt there will be any tangling issues here. My only issue with the spool itself is that there is only one spot along the border to hold the thread. I would have preferred a few holes, but that's a minor thing. Came in a vacuum pack with a desiccant bag inside. adhesion and print quality. I didn't have any adhesion issues at all, but I also didn't stick to the recommended temperatures on the packaging/list. The temperature is too high in my opinion, but it may vary depending on the printer. I'm running this through Ender 5 Pro. As you can see from my photos, there was rope inside the object, but not much. They were very thin and easy to clean. Here are the settings I would recommend for most people: Nozzle Size: 0.4mm brass Nozzle Temperature: 205 degrees Celsius for the first layer, 200 degrees for all other layers Layer Temperature: 60 degrees for the first few layers, 58 degrees for all other layers. Results at these temperatures with this thread. Start with this for your printer and go up or down in 5 degree increments to find your best spot.