Review on 🔦 NightEye H13 9008 LED Headlight Bulbs, 26000LM 120W 800% Brightness, LED High/Low Beam Headlights Conversion Kit, Plug and Play, 6500K Cool White IP68 Waterproof, Set of 2 by Antonio Edan

I recently bought an 07 Mustang and have switched all my cars from hazy yellow incandescent to bright white LED. The Mustang uses one bulb for both low and high beam, so I wanted to make sure I had a compatible bulb. They fully meet all requirements! Installation was easy. with a few tips I'll share. Ordinary bulbs easily crept out of the headlights. But actually taking them off was a tricky task as the retaining clip got stuck so I ended up snapping off that small piece and they came loose. No problem as the new bulbs are tight and I'm not worried about them going out. Another problem is that the standard bulbs left their little rubber seal inside the headlight housing. So when I tried to put a new bulb in, it refused to install properly. I spent a few minutes getting it turned on properly but nothing worked - 3 tabs didn't move. I FINALLY figured out that the standard bulb left a red ring/seal around the hole. When I took it off, the new bulbs snapped into place in seconds. God. SO MAKE SURE you remove the o-ring from the old bulb (red on my old bulbs in the photo) as new bulbs have new o-rings (orange on new bulbs). Once the new bulbs are in place, you can rotate the actual bulb to align it properly. When installing, it must be vertical. Once it snaps into place with the finger tabs, take the fan housing and twist a real lightbulb. They are way better than the old yellow lightbulbs. Watch the video about near and high beam. RECOMMENDED