Review on 🖨️ High-Quality Washable Printing Photopolymer Non Clear - Rich OPTO by Kevin Mariappan

This was my first purchase of water washable resin and it won't be the last. It's very similar in performance to other resins I've bought, except I can flush with water instead of IPA. The color is very pleasant light gray, almost odorless. I mean. If you stick your nose in a bottle, it stinks a little. However, no odor could be detected during printing. In addition, this resin can make parts that are slightly less brittle than standard resin. One of the parts I've created and printed is a car door panel that needs to be bent slightly to snap into place. The standard resin I used didn't allow for sufficient flexing without breaking. This resin seems to take that bend well. The exposure time was about the same as the standard gray AC resin I used. I limit the cure time to 1-2 minutes or less depending on the size of the printed part and this resin seems to like the reduced cure time. So far I am very happy with this resin and it will be my new resin for simple models and details.