Review on ENOMAKER Upgrade Stability Accessories Creality by Mohmed Burt

Ender 3 is not a perfect machine with a straight edge between the horizontal and vertical planes, so it takes some time to add a second Z-axis to even out the initially uneven surface. Patience. Installing all the major components is easy enough, and moving the PSU works well for both the factory unit and the upgraded Meanwell PSU. To keep everything as square and symmetrical as possible I would recommend loosening the couplers on both the original motor and the new motor and then using the same tool or object to realign them to the motor axis to keep the spacing constant. from the motor housing. Then, before attaching the lead screw mounts at the top, raise the gantry all the way up and lock it at that point so misalignment of the posts will not put undue pressure on the lead screw, causing it to bend, flex and add more pressure as you try yourself to move. The whole installation took about 45 minutes which took me a while to keep everything as simple and smooth as possible. Aligning the gantry is as simple as unscrewing the bed attachment wheels until they loosen and tightening the bed at a specific corner. Then lower the portal until it just touches the bed on the left. Move the carriage to the right side of the bed, disconnect the new Z motor to release the lock and slowly rotate the lead screw until the carriage is the same distance from the bed as it was on the left side. Leave it there until you reconnect the motor. Retighten the bed, follow the bed reset and leveling procedure, and you're done! It takes about 5-10 minutes to flatten and just a few minutes to check every few prints.